USB memory control in Macro executor

USB memory control in Macro executor

 

USB MEMORY CONTROL

USB memory control can be executed using the same commands that are used for the reader/puncher interface
and Memory card control. USB memory control is enabled when bit 7 (EXT1) of compile parameter No. 9002
is set to 1.
G330 : USB memory open
G331 : USB memory close
G335 : 1-byte reading
G336 : Data writing
G337 : Macro variable input
G338 : Macro variable output
G339 : File information reading/file deletion
Completion codes are also used, as with the reader/puncher interface and Memory card control.
See following section “Completion codes” for details of completion codes.

 

 

For more information, please download the reference document


未经允许不得转载:数控文库 » USB memory control in Macro executor

分享到: 更多 (0)

评论 抢沙发

评论前必须登录!

立即登录   注册

数控库-数控机床电气调试维修资料库

数控博客联系我们
切换注册

登录

忘记密码 ?

切换登录

注册

我们将发送一封验证邮件至你的邮箱, 请正确填写以完成账号注册和激活